Ann Arbor, MI · Circuit Breaker Buyers
Circuit Breaker Buyers Near Me — Ann Arbor, MI
If you have circuit breakers to sell in Ann Arbor, the fastest route to a real number is nameplate photos and a rough quantity. We price against the working replacement market for this equipment, subtract our own removal cost openly, and send back a written itemized offer the same business day.
Same-day written offer
Get a Written Offer
Send the asset list, or just describe what is in the room. We come back the same business day with a written, itemized offer.
Faster: call 954-740-1983
Email an asset list to electricalequipmentbuyers@gmail.com
Mon–Sat, 7am–7pm CT. We never resell your contact information.
- Location
- Ann Arbor, MI
- Desk
- Circuit Breaker Buyers
- Ratings
- 15 A – 6,000 A, LV through 38 kV
- Offer
- Same business day
- Payment
- Before load-out
- Phone
- 954-740-1983
This city
Circuit Breakers buyers serving Ann Arbor
Ann Arbor sits in Michigan, where DTE Energy, Consumers Energy, Lansing Board of Water and Light feed the load and I-94, I-75, I-96 and I-69 carry the freight. Sites near those corridors cost us less to service, and that shows up in your offer rather than in our margin. Detroit, Grand Rapids, Lansing, Flint and Warren are routine stops and Ann Arbor work routes with them.
Documentation travels with the job: a certificate of insurance naming your entity, a W-9, a signed purchase agreement itemizing each asset and its price, oil or PCB manifests where applicable, and weight tickets or a bill of lading for what leaves the Ann Arbor site.
| Item | Detail |
|---|---|
| Ratings | 15 A – 6,000 A, LV through 38 kV |
| Scope | Molded case, insulated case, air, vacuum |
| Nameplates | Square D, Schneider Electric, General Electric, Siemens, Eaton, Cutler-Hammer, ABB, Westinghouse, Federal Pacific, ITE, Zinsco, Challenger, Allis-Chalmers |
| Condition | Working, retired, water-damaged or already dismantled |
| Minimum | One section, one unit, or a whole plant lot |
Equipment
What we take out of Ann Arbor sites
Molded-case breakers
15 A through 2,500 A molded-case breakers of every major line, bolt-on and plug-in, with or without trip units. Discontinued Federal Pacific, Zinsco, Challenger, ITE and older Westinghouse frames are in constant demand for repair work.
Low-voltage power and insulated case
Drawout and fixed low-voltage power breakers — GE AKR and Magne-Blast lines, Square D Masterpact and DS, Eaton Magnum, Siemens — 800 A through 6,000 A, with electronic or electromechanical trips. Matched sets from a single switchgear order are worth quoting together.
Michigan specifics
Michigan work is tooling-cycle work. Stamping plants, body shops and powertrain lines across the Detroit metro and down the I-94 corridor reconfigure on model changeovers, and each changeover frees motor control centers, drive cabinets, dry-type transformers and feeder cable. The plants that close outright release whole electrical scopes, including gear from the 1960s and 70s that operators elsewhere are still hunting to match. Grand Rapids office furniture and food processing, the Midland chemical complex and the foundries around Saginaw and Muskegon add to it. DTE Energy and Consumers Energy both run large distribution replacement programs. Michigan is also where we see the most unit substations still sitting energized on the pad, which is fine — we handle the de-energized removal.
Nearby
Nearby and related
Ann Arbor routes with these nearby Michigan sites:
Common questions
Ann Arbor questions
What happens to the equipment after you buy it?
Serviceable gear is tested, reconditioned where needed and resold as replacement equipment — that resale is what funds your offer. What cannot go back into service is dismantled for copper, aluminum and steel recovery through permitted processors, with regulated fractions documented.
Do you buy equipment that is still energized and in service?
Yes, and most of what we buy is. We quote it now and remove it on your cutover date. Telling us at the quote stage which Ann Arbor assets are still live lets us build the phasing and the clearance coordination into the schedule from the beginning.
Our electrical room is in a basement with a tight door. Is that a problem?
It is routine. Switchgear sections, transformers and gensets frequently have to be cut down or partially disassembled to clear a door width, an elevator limit or a stair turn. The access survey at your Ann Arbor site establishes the path before we commit to a date, and that cost is already inside the offer.
Will you take the equipment we cannot sell along with the good items?
Yes, and this is usually why sellers choose us. Cherry-picking leaves you holding the leftovers of the leftovers. We price the Ann Arbor lot as a whole — good gear, obsolete gear and the scrap fraction together — so the electrical room ends up genuinely empty.
Do you provide documentation for surplus property or audit records?
Yes. Itemized purchase agreements, weight tickets, bills of lading, oil disposal manifests and recycling documentation are standard on Ann Arbor purchases. Public agencies and audited facilities get the paperwork their process requires without having to ask twice.
Circuit Breakers in Ann Arbor?
One call, one written offer, one crew. Payment before the trailer leaves.